Difference: Atf2LwHwOTR ( vs. 1)

Revision 109 Dec 2010 - LaurieNevay

Line: 1 to 1
META TOPICPARENT name="Atf2LwDaqHardware"

OTR Setup


PI M-410.2S Stage - range 100mm.
PI Mercury C663 Single Axis Controller - http://www.physikinstrumente.com/en/products/prdetail.php?sortnr=900550
JAI GigE CM-040GE CCD Camera

Large rotation stage (thorlabs?)
Thorlabs actuators for 1st turning mirror vertical and horizontal, lens z position (along optical axis).
Thorlabs filter rotation mount.

Look in extlw/doc/manuals and extlw/sof for file with these names for more details / drivers / software.

Specific Notes

Thorlabs controller serial numbers and funcitons

Controller Serial Number Model Axis
    Lens Z
    M1 horizontal
    M1 vertical


Used OTR alignment laser inserted upstream by manually inserting 'inserter' by connecting plug. Must disconnect afterwards to remove. Didn't touch alignment laser alignment as it points at our detector and has been referenced. Remember to open shutter on laser.

Chamber was at location of last known collisions chaver = 943, chahor = -150

The notch made by the high power laser was clearly visible. At the top of this (bottom as camera upside down - oops.) was a small notch / channel made by the RGA only when being used for alignment of the chamber / manipulator. This was aligned to the centre of the camera.

NOTE collisions were found around chaver = 340, chahor = 350 in the last shift so this area is slightly wrong. See calibration notes further down for area of ccd and therefore probable move needed to find OTR.

Stage Positions

0 - OTR 97200 - Laserwire

It has not been programmed to be 'homeable' and there are hard limits at each position. These positions have hard stops and if you go past them on the stage the motor will just skip and the readback will continue so it will think eventually it's reached the position. You then have to redefine the home position. This was done very quickly to put it in before lock up and it does work, just now ideally.

VI is in extlw/daq/labview/Projects/Laserwire/06_otr_swtich_stage - PI_Stage.vi

Comport default is set in the vi - from memory it's com port 7.


The camera is read out using the GigE standard. This can be used in labview.

Camera.vi is on the desktop of extlw-win1.



See Laserwire log book pg 41 and 42 for full details


In short image has a scale of 0.888microns / pixel and magnification factor of 9.43 (ie pixels are (8.37x8.37 microns). This makes the imaging area 874x655 microns (H x V).


Settings just to customise this page

  • Set STYLESIDEBAR = off
  • Set ALLOWTOPICVIEW = Public.TWikiGuest, Public.JohnAdamsInstituteGroup
  • Set MYTITLE = - ATF2 laser wire project - OTR
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2021 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding RHUL Physics Department TWiki? Send feedback