# 20130225 Nonlinear Scan Optimisation

• all files save in extlw/sim/20130225_nl_scan/

Nonlinear scans often produce a fit uncertainty for sigma of about 0.1um. This is ok, however, better is always better and more importantly, fitting the same data repeatedly often yields different results that can be different by greater than the uncertainty. Whilst not ideal, this can be understood as being a four parameter fit, it is often possible to minimise successfully with one parameter different from a previous fitting by adjusting the others. This is usually shown with data from different scans as each scan is unique and the route taken to minimum often is also. Therefore, if we can't improve this, we should improve the uncertainty on individual points and secondly (more for time purposes) the number of points and their location.

More samples corresponds to greater statistics but also a greater overall length of scan (linear in number of samples), however, the benefit from the statistics reduces as it's dependent on 1/sqrt(nsamples). At some point, a significantly

## Version 1 - used before 20130222

• Range: 200um
• Cubic with minimum step size
• Minimum step size: 0.2um

## Version 2 - developed during shift on 20130222

• Range: 150um
• Cubic with minimum step size
• Minimum step size: 0.35um

## Comparison

Generate model overlap integral data for different sigmas with the same normalisation and background over the same range. Use 1001 points to see smooth curve with linear samples for now.

sigma = arange(0.6,1.61,0.2)
data   = [lwIntegral2.OISetEV(yarray,0,200,s,1.0,0.0,0.0) for s in sigma]
datad = dict(zip(sigma,data))
datad2 = {}
for key,val in datad.iteritems():
newkey = str(round(key,2))
datad2[newkey] = val
for key in datad2:
plot(yarray,datad2[key],label=('$\sigma_{ex}$ = '+key+'$\mu$m'))


Saved this data as

different_sigmas.dat

• Uncertainty on the points is around 5% from typical data so far.
• Let's aim for 50 points for scanning.
• Use sigma = 1.0 microns for comparison.

• It seems important to have a few points close together at the top incase you miss the middle when specifying where the centre of the scan should be.
• But you also want more points closer together down the sides.

## Version 3

• single point in specified centre: then considering points only to the positive side for now (simply flip for others)
• so 50 points + 1 for centre -> 25 either side:
• step size 0.3um for 2 points
• step size 0.7um for 10 points
• step size 1.5um for 5 points
• step size linearly increases for remaining 7 points from 2um to 10um

This topic: PP/JAI > LaserWire > Atf2Laserwire > Atf2LwLogBook > Atf2LwLogBook20130225NLScanOptimisation
Topic revision: r3 - 25 Feb 2013 - LaurieNevay

Copyright © 2008-2022 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding RHUL Physics Department TWiki? Send feedback