PETRA-III Laser-wire

Patch Panel Connector Description

The patch panel is located at the base of the 42U rack in the laser room.

N-type connectors

# Signal Cable# Comment
1 Calorimeter Output   -ve signal
2 BPM32   Used for checking timing
3 BPM32    
4 BunchUhr    
5 BunchUhr    

BNC connectors

#Sorted ascending Signal Cable# Comment
1 +12V to tunnel rack   Turns on remote power to tunnel rack
2 Status of tunnel rack   TTL: high=rack on, low=rack off
3 Calorimeter LED   Never used - parameters unknown
4 not used    
5 Power meter   which PM?
6 Power meter   which PM?
7 Wincam trigger   Used when wincam used for measurements in tunnel


This topic: PP/JAI > LaserWire > Petra3Laserwire > Petra3RackPatchPanel
Topic revision: r3 - 05 Mar 2013 - GaryBoorman
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2022 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding RHUL Physics Department TWiki? Send feedback