PETRA-III Laser-wire
Patch Panel Connector Description
The patch panel is located at the base of the 42U rack in the laser room. N-type connectors| # | Signal | Cable# | Comment |
|---|---|---|---|
| 1 | Calorimeter Output | -ve signal | |
| 2 | BPM32 | Used for checking timing | |
| 3 | BPM32 | ||
| 4 | BunchUhr | ||
| 5 | BunchUhr |
| # | Signal | Cable# | Comment |
|---|---|---|---|
| 4 | not used | ||
| 3 | Calorimeter LED | Never used - parameters unknown | |
| 2 | Status of tunnel rack | TTL: high=rack on, low=rack off | |
| 1 | +12V to tunnel rack | Turns on remote power to tunnel rack | |
| 7 | Wincam trigger | Used when wincam used for measurements in tunnel | |
| 5 | Power meter | which PM? | |
| 6 | Power meter | which PM? |
This topic: PP/JAI > LaserWire > Petra3Laserwire > Petra3RackPatchPanel
Topic revision: r3 - 05 Mar 2013 - GaryBoorman
Copyright © 2008-2023 by the contributing authors. All material on this collaboration platform is the property of the contributing authors. Ideas, requests, problems regarding RHUL Physics Department TWiki? Send feedback